A hand pipe threader die tool set is an assortment of items designed to facilitate the cutting, shaping, and restoration of pipe threads. The components in such a set generally include a die holder, a die, a tap, and a reamer. The die holder secures the positioned die as the tap is rotated, effectively cutting threads into the pipe. The reamer may then be used to smooth out any irregularities in the threads.
Before using a hand pipe threader die tool set, you must figure out what size pipe you’re handling. This set has a die for every size of pipe available, so simply choose the right one for your needs. Once that’s done, firmly attach it in the die holder.
It’s finally time to decide on your tap. After all, this is the device that will ultimately bore through the piping material and cut the threading. There are two varieties when it comes to taps: taper and bottoming taps. The former should be used if you want to drill all the way down your pipe, while the latter provides more of a partial-bore effect. More often than not, a taper tap will suit your needs best.
After selecting a tap for the job, carefully install it in the holder and commence turning it. Gradually, as the tap rotates, threads will be cut into the pipe. Make sure to turn the tool at a measured pace with steady pressure to ensure evenness. Once a few revolutions have been completed, withdraw the tap and check if the threads are neat and tidy; if not, the reamer can be deployed to rectify them.
With your threads now sparklingly pristine, it’s time to screw the pipe up! Bite the bullet and connect the halves of the pipe by hand. Give it a good twist until it’s tight, then reach for the die tool set and place the final seal on your masterpiece.
For a successful hand pipe threading process, be sure to refer to the instructions accompanying the tool set. Incorrect use may lead to harm to both the tools and the pipe, so it’s wise to consult a representative from a local hardware store if you are uncertain about the steps to take.